Installation guide

Alacritech Accelerator Users Guide: Microsoft Windows Edition 5-4
5.5 Event Log Errors
This section covers entries written to the Event Log. You can view the Event Log from
the Event Viewer located in the Administrative Tools folder on the Start Menu, located
under Programs.
Problem
Solution
Event Log reports
"SLIC<x> Has de-
termined that the
adapter is not func-
tioning properly"
 Run Diagnostics from NCPA. See the procedure in Chapter
3.
 Contact Alacritech technical support for assistance. This is
probably the result of a malfunctioning adapter.
5.6 Connectivity Problems
This section covers problems with network connectivity.
Problem
Solution
There is no connec-
tivity at all with other
computers on the
network.
Pinging does not
work.
 Make sure that the cables are attached securely at both
RJ-45 connections (adapter and switch) and that the
network cable is otherwise functional.
 Make sure that the network cables are plugged into the
correct port of the adapter. The driver will list the slot and
port for the interface.
 Check the LED indicators on the adapter. Each port has
LEDs for link/link speed and activity. These lights help
indicate if there is a problem with the adapter, switch or
cable. Refer to the "LED Function Indicators" chart be-
low.
5.6.1 Alacritech SEN2002XT, SEN2001XT, SES2002XT and SES2001XT Accele-
rator LED Function Indicators
LED
Indication
Meaning
ACT/LNK
Green On
The port is connected to a valid link partner.
Green Flashing
The Accelerator is sending or receiving network
data.
Off
The Accelerator is not connected to a valid link
partner.
10/100/1000
Off
A 10 Mbps link has been established (if the
ACT/LNK LED is on or flashing).
Green
A 100 Mbps link has been established.
Yellow
A 1000 Mbps link has been established.