Installation guide

Alacritech Accelerator Users Guide: Microsoft Windows Edition 4-7
4.6 Configuring Advanced Driver Features
The command line interface for configuring advanced interface properties was not
complete at the time this page is was written. The idea is to be able to use slicutil to do
all of it, but for now, slicutil will only manipulate some, but not all, advanced interface
properties for teamed interfaces. Normal interfaces have to be handled with the reg
command, as does changing team properties that are not supported by slicutil. VLAN
interfaces have no advanced properties, and instead reflect the advanced settings of
the underlying physical interface.
4.6.1 Configuring Teamed Interface Advanced Properties Using slicutil.exe
Teamed interface advanced properties are manipulated using the syntax:
slicutil team modify teamid=<Id> property=value [...property=value...]
The following properties are supported:
Property
Description
Possible Val-
ues
Default Value
Type
Team Type:
Either GigabitEtherChan-
nel/802.3ad or
Hot Standby Failover
FEC =
802.3ad/GEC
hsb = Failover
only
FEC =
802.3ad/GEC
Property
All properties except team-
type
Default
None
IPCsumIPv4
IPv4 Checksum Offload
0 = Disabled
1 = TX Enabled
2 = RX Enabled
3 = TX&RX
Enabled
3 = TX&RX
Enabled
TCPCsumIPv4
TCP Checksum Offload
(IPv4)
0 = Disabled
1 = TX Enabled
2 = RX Enabled
3 = TX&RX
Enabled
3 = TX&RX
Enabled
TCPCsumIPv6
TCP Checksum Offload
(IPv6)
0 = Disabled
1 = TX Enabled
2 = RX Enabled
3 = TX&RX
Enabled
3 = TX&RX
Enabled
Lsov1IPv4
Large Send Offload Version 1
(IPv4)
0 = Disabled
1 = Enabled
1 = Enabled
Lsov2IPv4
Large Send Offload Version 2
(IPv4)
0 = Disabled
1 = Enabled
1 = Enabled