operation manual

469861_b 61
Operation
6 OPERATION
DANGER!
Danger of fatal injury
and danger of extremely
severe injury.
Lack of knowledge of the
safety instructions and op-
erating instructions can
lead to extremely serious
and even fatal injury.
■
Read and follow all
safety instructions and
instructions for use in
these operating instruc-
tions as well the operat-
ing instructions which
are referred to before
you start using the chain
saw.
■
Comply with working time regulations in force
in your country.
■
Grip the rear saw grip firmly with your right
hand (right-handed operator) and the front
grip with your left hand, and hold them tightly.
■
Do not release the grips for as long as the
engine is running.
■
Do not use the chain saw if you are:
■
Tired
■
Unwell
■
Under the influence of alcohol, medicines
and drugs
6.1 Determining the charge status of the
rechargeable battery (04)
There is a control panel with a push-button (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
1. Press the push-button (04/1).
The charge status displays light according to
the charge status of the rechargeable battery.
2. Read off the charge status.
Lighting LEDs Charge status of the re-
chargeable battery
Green (04/2) The rechargeable battery is
fully charged.
Green (04/3)
and (04/4)
Rechargeable battery is
charged to over 50%.
Green (04/4) Rechargeable battery is
charged to less than 50%.
Red (04/5) The rechargeable battery is
fully discharged or the re-
chargeable battery has been
overheated/undercooled.
6.2 Check the saw chain oil
Procedure see chapter 5.8 "Filling saw chain oil
(09)", page60.
IMPORTANT!
Danger of damaging the
chain saw
The chain saw will be se-
verely damaged if there is
too little or even no saw
chain oil in the tank or it has
dried/is sticky. Dried/sticky
saw chain oil can lead to
damage to oil-channelling
components or the oil pump.
Damage also occurs if
used oil is used. The use
of used oil leads to envi-
ronmental damage!
■
Each time before start-
ing work, check that
enough saw chain oil is
present in the tank.
■
If the oil level is low, re-
fill saw chain oil.
■
Do not use any used oil!