operation manual

Table Of Contents
469861_b 61
Operation
6 OPERATION
DANGER!
Danger of fatal injury
and danger of extremely
severe injury.
Lack of knowledge of the
safety instructions and op-
erating instructions can
lead to extremely serious
and even fatal injury.
Read and follow all
safety instructions and
instructions for use in
these operating instruc-
tions as well the operat-
ing instructions which
are referred to before
you start using the chain
saw.
Comply with working time regulations in force
in your country.
Grip the rear saw grip firmly with your right
hand (right-handed operator) and the front
grip with your left hand, and hold them tightly.
Do not release the grips for as long as the
engine is running.
Do not use the chain saw if you are:
Tired
Unwell
Under the influence of alcohol, medicines
and drugs
6.1 Determining the charge status of the
rechargeable battery (04)
There is a control panel with a push-button (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
1. Press the push-button (04/1).
The charge status displays light according to
the charge status of the rechargeable battery.
2. Read off the charge status.
Lighting LEDs Charge status of the re-
chargeable battery
Green (04/2) The rechargeable battery is
fully charged.
Green (04/3)
and (04/4)
Rechargeable battery is
charged to over 50%.
Green (04/4) Rechargeable battery is
charged to less than 50%.
Red (04/5) The rechargeable battery is
fully discharged or the re-
chargeable battery has been
overheated/undercooled.
6.2 Check the saw chain oil
Procedure see chapter 5.8 "Filling saw chain oil
(09)", page60.
IMPORTANT!
Danger of damaging the
chain saw
The chain saw will be se-
verely damaged if there is
too little or even no saw
chain oil in the tank or it has
dried/is sticky. Dried/sticky
saw chain oil can lead to
damage to oil-channelling
components or the oil pump.
Damage also occurs if
used oil is used. The use
of used oil leads to envi-
ronmental damage!
Each time before start-
ing work, check that
enough saw chain oil is
present in the tank.
If the oil level is low, re-
fill saw chain oil.
Do not use any used oil!