Instructions

en
Display indications
20 HW 5000-6000 FMS PREMIUM
Normal operation mode
Display indicator Switching condition Function / actions
Pump running or switched
off
Press the MODE button for longer than 3 se-
conds, the operating language is activated.
Change the operating language by pressing the
MODE button (30). Confirm the new language by
pressing the SET button
Pump switches on and starts
to draw water.
Initial commissioning Pump filled with water,
suction and pressure side connected, water pre-
sent on the suction side. Pump connected to
mains. Closing off devices in the pressure line
are open.
A rotating X behind the normal symbolises that the pump is ON
Pump does not switch on
after self-test. In operation
mode, the pump does not
switch on.
Top up with air and then press the SET button.
Carry out the initial commissioning again. For the
air pressure see technical data Page 3
Running text TOP UP 1.5 BAR
Pump switches off. Dry run-
ning after 90 seconds
Check the suction line and then press the SET
button. Carry out the initial commissioning again.
Running text CHECK WATER INFEED
Pump running. Pump delivering water. Storage vessel being fil-
led. Part of the water is being drawn off.
Pump switches off. Pump has achieved the set switch-off pressure.
Pump switches on Pump has achieved the set switch-on pressure.
Additional functions
Display indicator Switching condition Function / actions
Pump running. Flow rate:press the MODE button until the flow
rate appears.
Running text FLOW RATE