User manual

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany Tel.: [phone] · www.akytec.de
5
Fig. 5.1 Wire preparation
Fig. 5.2 Connecting the wire to the terminal
Do not use wire end ferrules to connect
stranded wires.
To connect fine-stranded wire, tin the wire
end.
To connect solid wire, push the wire into the
terminal.
To connect stranded wire, press the release
lever and push the wire into the terminal.
Fig. 5.3 Disconnecting the wire
Press the release lever to free the wire.
Fig. 5.4 Mounting
– The electrical connections are shown in Fig. 5.5-5.8, the terminal assignments in Table
5.1.
– Ensure that the device is provided with its own power supply line and electric fuse I = 0.5
A.
– Solid conductor cross-section: 0.2…0.8 mm². Stranded conductor cross-section:
0.45…0.7 mm². Wires should be stripped for approx. 8 mm.
5.1.1 Input
Fig. 5.5 RTD sensor wiring
Fig. 5.6 TC sensor wiring
5...7