User manual

Operation
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: [phone] · www.akytec.de
8
7 Operation
After the power supply is switched on the following values will be displayed successive-
ly:
1. Firmware checksum (8 digits, ticker-tape)
2. Firmware version (Ux.xx)
3. Measuring voltage
If the measuring voltage is less than 5 V the error message
0000
will be displayed.
If the measuring voltage is greater than 400 V the error message
HHHH
will be dis-
played.
If the measuring voltage is not displayed correctly, check the connecting cable and the
polarity.