Instructions

Mounting
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: [phone] · www.akytec.de
7
1st one. The connector under the right cover is used to connect PR200 to the 1st PRM or the 1st
PRM to the 2nd one.
To enable control by PR200, the module should be added to the PR200 configuration in the pro-
gramming software ALP (see 5 ‘Configuration’).
Fig. 4.1
When connected, the flat cable should be placed in a special recess under the cover to enable
PRM to be pushed close to PR200.
Fig. 4.2
4.3 Wiring
The safety precautions from the section 4.1 must be observed.
Terminal assignment is given in Table 4.1. Electrical connections for inputs and outputs are given
in Fig. 4.3…4.5. Maximum conductor cross-section is 0.75 mm².
Table 4.1 Terminal assignment
№ Designation Function № Designation Function
1
AC230V L /
DC24V -
Power supply AC / DC * 13 DO1 Digital output DO1
2
AC230V N /
DC24V +
Power supply AC / DC * 14 - Common contact DO1...DO2
3
COM1
Common minus pole DI1...DI4
15
DO2
Digital output DO2
4
DI1
Digital input DI1
16
DO3
Digital output DO3
5
DI2
Digital input DI2
17
-
Common contact DO3...DO4
6
DI3
Digital input DI3
18
DO4
Digital output DO4
7
DI4
Digital input DI4
19
DO5
Digital output DO5
8
COM2
Common minus pole DI5...DI8
20
-
Common contact DO5...DO6
9
DI5
Digital input DI5
21
DO6
Digital output DO6
10
DI6
Digital input DI6
22
DO7
Digital output DO7
11
DI7
Digital input DI7
23
-
Common contact DO7...DO8
12
DI8
Digital input DI8
24
DO8
Digital output DO8
* Depending on the device modification (PRM-230 or PRM-24)