Instructions

Circuit program development
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: [phone] · www.akytec.de
80
Fig. 7.26
7.10 Execution sequence
Calculation of the values for outputs and delay lines is performed in a certain order. To
see this order click the arrow near the icon in the toolbar Service and select the De-
lay lines or Outputs (Table 2.6).
Fig. 7.27
To change the order, double-click an output or a delay line and enter the desired number.
Fig. 7.28
Click the icon to deactivate the edit mode.
7.11 Simulation
Use the simulation to proof the correctness of the created program. Only the offline sim-
ulation is currently possible. The simulation enables to analyze the values of all signals
within the circuit program. Change the values at the digital and analog inputs as well as
of variables and constants and check the values at the outputs.
7.11.1 Operation
To start / stop the simulation mode, click the icon Simulation mode in the toolbar
Service (Table 2.6). A new toolbar Simulation is displayed with the following controls:
Fig. 7.29