Instructions

Circuit program development
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: [phone] · www.akytec.de
75
Fig. 7.8
7.3 Using of variables
To add a variable to the program click the corresponding icon in the toolbar Insert (Table 2.6),
then click the workspace to place the variable block.
Fig. 7.9
Fig. 7.10
To reference a variable to the block use the icon in the row Variable in Property Box.
The variable table opens, but only the appropriate tabs in the table are visible. The selec-
tion of the displayed variables is determined by the type of the block.
Fig. 7.11
Select a variable or create a new one in the variable table (sect. 5) and confirm with OK.
Fig. 7.12
Use network variables to exchange data with other devices connected to the target de-
vice over network. For further details about using of network variables, refer to sect. 7.6.
If a variable block is highlighted in red, it means that the creation is incorrect or not com-
pleted.