E16/A05 Wall-mounting Installation YPN) Gad it rH Unpacking Please make sure the package contains the following items: Universal Accessories: I AOS/E16x 1 Wall: mounting bracket 1 (5 [Mm M2.
E16/A05 Wall ting Installation NIL Ci aad Shari 1.1.2 With 23 inches embedded single-gang robin the Wall Fix the wall-mounting bracket on the single-gang junction Finish the bracket Installation. bandwidth the two MAXIMA cross head screws. 1.2 Without embedded gang box in the wall EF) According to the position of the cable, put the wall mounting Take off the wall mounting and drill the four \ bracket closely on to the wall and mark the four partitioning marked postponing holes ond he wire holes holes, while
SYN Sed Wall Terr AKUVOX intercom hl Fon ro 2.Step 2: Device Installation 2.1 Device Installation without Digital Forehead or Wrist Temperature Detector Take out the device along with the wiring Lead the wires from the wall mounting bracket and the detector cover, sealing pressing plate, rubber plug through the square hole on the wiring cover, connecting them to and corresponding screws. the corresponding interface of the main board.
E16/A05 Wall-mounting Installation SET AKUVOX intercom Quick Guide 2.2 Device Installation with Digital Forehead Temperature Detector {Optional} Take out device and the digital forehead Fasten the detector on to the nuts on the device’ 5 wiring cover temperature detector and then take out with two M3X10.
E16/A05 Wall-mounting Installation Quick Guide Fretwork holes of the detector Tighten the detector on northerner Take out the device along with the onto the Installation pins on the threaded bolt with two M2 cross head wiring cover, sealing pressing wall bracket ether on the lek or screw using the Allen wrench attached in plate, rubber plug and right according to your the someway on bath side. corresponding screws. preference.
3701 Rcd Wall-mounting Installation AKUVOX intercom rer Device Wiring To. ] iia Lo i] i Gaming . a Wire Length & AWG Table Please follow the properly measured wire gauge/length to Install device: 20406 GEWGAW 24AWG 26AWG 12V 1A Adapter 20m <10m 1 1 Application Network Topology Siva.
317/00 Ey Wall-mounting Installation Habakkuk intercom ror Hs Configuration LIP address Checking: Long press any where on the initial screen for approximately five seconds to go to project PIN screen where you enter the default PIN “admin” and press Confirm tab to go to Setting screen where you press Info icon to check for the device IP address. { for E16 series door phone only) 2.Account Registration:On the web interface, go to the path Account > Basic page to register and fill in the account information.
