E12 Before you being using the device, please check the version you obtained and ensure that the following items are included in the shipped box: Universal Accessories: E12 x 1 Plastic Wall Anchor x 4 M3x4 screw x 4 Wall mounting bracket x 1 Back cover x 1 Torx Wrench x 1 ST4x20 screw x 4 7-pin cable x 1 6-pin cable x 1 Torx screw x 2 Wall-mounting template x 1 Diode x 1 Mic Photosensitive sensor Camera RF card reader Call button E12
E12 Indoor and outdoor installation are supported. If installing the device outdoors, please do not place device under direct sunlight. If installing the device indoors, please keep device at least 2 meters away from light, and at least 3 meters away from window and door. Backlight Direct sunlight According to the position of the reserved wires on the wall, stick the wall-mounting template vertically to ensure that the wires can come out of the shadow position of template.
E12 Connect the wires to the interface of the device as needed (for details, refer to “Device Wiring”). After arranging the wires, tighten the back cover using four M3x4 screws to the device. Hang the device on to the two square hangers on the wall-mounting bracket, then use the Torx Wrench attached to tighten the bottom of the device with two Torx screws. The installation is completed.
E12 Warning When you connect a device containting a coil, such as a relay or an electromagnetic lock, it is necessary to protect the intercom against voltage peak while switching off the induction load. For this way of protection we recommend a diode 1 A / 200 V (included in the accessories) connected antiparallet to the device.
E12 1. While E12 starts up normally, hold the call button for several seconds after the LED light turns blue, voice system will enter IP announcement mode. 2. In announcement mode, the IP address will be announced periodically. 3. Press Call Button again to the announcement mode. 4. In announcement mode, phone announces "IP 0.0.0.0" if no IP address is gained. Make a call: 1. Press the call button to call indoor SIP Phone. 2.
E12 Name Status Indicator Status Description Blue Light Always On Normal status Calling Blue Breathing Light Blue Light Always On > Red Light Always On > Purple Light Always On Receiving a call Restarting Red Breathing Light Network is unavailable / Obtaining network Red/Purple Light Flashing Firmware upgrading Purple Light Always On Talking Note: For more LED settings, please refer to E12 webUI: Intercom -> LED Setting.
