Installation Instructions

Installation Time: Approximately 15 Minutes

Tools Required: None

1. Choose the correct size and strength Mono-Post for the project based on

construction document.

2. Adjust screw to slightly short of the length needed between footer and

load carrying beam at installation location (Figure

➊

3. Place Mono-Post vertically between footer and beam with the adjustment

nut and screw on the footer (adjustable end down) (Figure

➋

4. Adjust screw to wedge the Mono-Post between footer and beam, tighten

until Mono-Post is ﬁrmly centered directly under the load carrying beam

and the footer below (Figure

➌

5. Additional screw adjustments may be made during construction to keep

ﬂoor level

6. Poured concrete basement ﬂoor permanently locks Mono-Post

adjustment (Figure

➍

TAMPER PROOF ADJUSTMENT: MONO-POST SHOULD BE POSITIONED WITH

ADJUSTMENT NUT AND SCREW AT THE FOOTER.

LOAD

CARRYING

BEAM

FOOTER

Note: Always consult Local Building Codes for

speciﬁc installation requirements in your area.

➋

ADJUSTMENT NUT

AND SCREW

➊ ➍

➌

mONO pOsts

iNstallatiON iNstruCtiONs

The Akron Products Company | 330.576.1750 | www.AkronProducts.com