Technical Specifications

Data sheets are subject to change without notice. For the latest version, please check the product page at www.tccmaterials.com
AKONA
®
MEDIUM-DUTY REFRACTORY MORTAR
Page 2
freezing during these 7 days, thermal insulation blankets or
plastic sheeting should be used.
The mortar needs to dry out completely prior to exposure to
fire. If not cured completely, the material will crack due to the
pressure caused by water evaporating within in the mortar.
Allow a minimum of 7 to 10 days before heat is applied. Full
curing times will vary with individual job conditions, sunlight,
temperatures, and humidity.
Clean Up
Use soapy water to clean hands and tools immediately after
use. Dried material must be mechanically removed. Use a
waste water hardener (e.g. Congelz
®
or similar product) for
cementitious waste disposal.
Limitations
• Follow all industry standard safety procedures when
handling, such as gloves and eye protection. Wear gloves at
all times, failure to do so can result in severe burns.
• Allow 7-10 days curing time before heat is applied.
• If mortar becomes unworkable, dispose of the unused
product. Do not retemper.
• Protect from rain within 24 hours of application (i.e., cover
the project).
• Set and cure times can vary with temperatures, humidity, and
exposure to sunlight. Cooler weather will slightly retard set
time – hot weather will slightly accelerate set time.
• This mortar is not recommended for casting applications, or
thickness applications greater than ⅜ in. (9.5 mm).
Safety
READ THE SAFETY DATA SHEET (SDS) BEFORE USING
THIS PRODUCT. SDS information is available on our website:
tccmaterials.com
Cautions
Read complete cautionary information printed on product
container prior to use.
This Product Data Sheet has been prepared in good faith on
the basis of information available at the time of publication. It is
intended to provide users with information about and guidelines
for the proper use and application of the covered Akona brand
product(s) under normal environmental and working conditions.
Because each project is different, TCC Materials cannot be
responsible for the consequences of variations in such
conditions, or for unforeseen conditions.
6. AVAILABILITY
To locate Akona products in your area, please contact:
Phone: [phone]
Website: tccmaterials.com
7. WARRANTY
Seller warrants that its product will conform to and perform in
accordance with the product specifications. The foregoing
warranty is in lieu of all other warranties, expressed or implied,
including, but not limited to those concerning merchantability
and fitness for a particular purpose. Because of the difficulty in
ascertaining and measuring damages hereunder, it is agreed
that Seller’s liability to the Buyer shall not exceed the total
amount billed and billable to the Buyer for the product
hereunder.
KEEP OUT OF REACH OF CHILDREN
WARNING: INJURIOUS TO EYES
Shelf Life Best when used within one year in
original, unopened bags
Storage Conditions Store dry, cool, out of direct sunlight.
Best to condition material to 50-80°F
(10°-27°C) before using.
Color
Gray
Akona
®
is a registered trademark of TCC Materials
2025 Centre Pointe Blvd., Suite 300
Mendota Heights, MN 55120 USA
www.tccmaterials.com
© Copyright 2019 TCC Materials
REV 06.19