Owner`s manual

Syncron User manual. Functions description. Front panel.
8

24. TIME BUTTON. This button changes the value of playing time
between:
"Elapsed" time played. The display will light "Elapsed". (More
information on page 11).
"Remain" time remaining on track. The display will light "Remain".
(More information on page 11).
The display shows a red bar sections formed giving us a visual
reference to the time played (elapsed) or “remaining". The way the
bar will show the time will vary depending on "Elapsed" or "Remain "
mode.
25. BUTTON SGL/CTN. This button has two functions:
1. We can select the play mode between:
- SGL (Single): a track is playing and the player enters PAUSE
- CTN (Continue): all tracks are played in order
This function remains active in Relay Mode
2. Pressing the button more than 1 second, activate and deactivate
the "Auto Cue. " Depending on whether or not active A. CUE (7.c.)
appears on the display.
FUNCTIONS DESCRIPTION.
Front panel
1. MIC 1 (JACK). This jack is used to connect a microphone to the
mixer. Connect your microphone via 1/4 inch jack. The volume
output level for microphone will be controlled by its own respective
VOLUME KNOB (2)
2. MIC LEVEL CONTROL. These rotary knobs control the output
volume of MICROPHONE 1 and MICROPHONE 2 (on the rear).
However, master volume is controlled by the MASTER VOLUME
CONTROL.
3. MIC TONE CONTROL. This rotary knob controls the frequency
response of MICROPHONE.
4. MIC ON/OFF/TALKOVER SWITCH. To set MIC on and off. When
we switch at the TALKOVER position, the mic1 and 2 on, the sound
level for everything other than that from the MIC will decrease to
around 20dB.
5. CUE PAN CONTROL. This function allows you to monitor the CUE
level as well as the Program (main output) level in your
headphones. When you turn the CUE PAN to the full left position,
you will only hear the CH 1 signal you playing, on the contrary you
will only hear the CH 2 signal you playing. If the CUE PAN KNOB is
set to the center position, you can cue the both signal channels you
playing.
6. CUE LEVEL CONTROL. This rotary knob is used to adjust the
headphone volume output level. Turn the knob in a clockwise
direction to increase the headphone volume.
7. PHONES JACK. This jack connector is used to connect your
headphones to the device allowing you to monitor the cue channel.
Always be sure the CUE LEVEL VOLUME (6) is set to minimum before
you put the headphones on.