Owner`s manual

Syncron User manual. Virtual DJ 7 LE Installation
22

On the front part of the Virtual DJ screen, you should select the AUX
control.
3. - Time Code MIDI mode: To work with TC (time code) need to
have the Cd's or Vinyl time code recommended by each
manufacturer's software.
Connect the inputs of SYNCRON, CD players or turntables with their
respective vinyl or CDs time-coded.
Select Setup / Audio Configure and configured it as follows:
- TIMECODES inputs, Chan 1 & 2: Deck 1 / Chan 3 & 4: Deck 2.
- HEADPHONES Master-Out: Channel 1 & 2 / Headphones: Channels
3 & 4.
- Sound Card 4-IN/4-OUT CARD SYNCRON.
In case the mixer panel works in internal mode, we should select
EXTERNAL MIXER instead of HEADPHONES in Outputs.
Other configurations see your Virtual DJ manual.
Traktor
Select Preferences / Audio Setup / Audio Device SYNCRON (4 In, 4
Out) tab.
Select in Preferences/ Output Routing/ Mixing mode the Internal
option if the mixer panel is set to "MIDI CTRL" and External if we
have selected the Mixer option in the 4th option of the internal
menu.
In Output Monitor (Internal) or Output Deck B (External) must select
the output "1: Front Left" of SYNCRON for the left channel and the
output "2: Front Right" to the right channel. In Output Master
(Internal) or Output Deck A (External) must select "3: Back Left" and
"4: Right Back" to the left and right respectively.
This configuration we have the master output on the rear outputs
of SYNCRON (Master balanced, unbalanced and Booth) and Monitor
output on SYNCRON front headphone jack.
In Input Routing must select the input "1: Front Left" and "2: Front
Right" in Input Channel A for the left-right respectively. Similarly
associate Input Channel B to the inputs "3: Front Center" and "4:
Low Frequency Effects " of SYNCRON.
From this standard configuration you can make any changes it
deems useful. If you want to use an external mixer must select
External Preferences / Output Routing / Mixing mode and assign to
each channel a SYNCRON output. You should select the MIDI CTRL
option in the mixer panel if you want available the analog outputs.
Remember that channels 3 and 4 are accessible only on the front
output for headphones.
Other configurations see your Traktor manual.
VIRTUAL DJ LE INSTALLATION
Here are the steps to follow to install Virtual DJ
NOTE: To install a new version of Virtual DJ LE need to uninstall any
version of Virtual DJ LE you have installed on your computer. One
computer only may have installed one version of Virtual DJ LE.
Windows
Run the Virtual DJ LE installer by double clicking the file icon
install_virtualdj_le_vx.yzmsi where x.y.z indicates the version of
software. Installation will begin with the welcome screen shown in
the figure below