Owner`s manual

Syncron User manual. Sound card setup
20

When using ASIO drivers need to configure Virtual DJ as explained
below:
Select Settings / Sound Configuration sound and configured as
follows:
- LINE-INs inputs.
-Outputs:
HEADPHONES: Master: Channels 1 & 2/ Headphones: Channels 3 &
4 (when mixer panel is in MIDI mode).
EXTERNAL MIXER: Deck 1: Channels 1 & 2/ Deck 2: Channels 3 & 4
(when mixer panel is in internal mode).
- ASIO Sound Card: ASIO Driver: Akiyama ASIO.
LINE-INs inputs are activated by selecting AUX on the deck you
want.
From this standard configuration you can make any changes it
deems useful. If you want to use an external mixer must select
EXTERNAL MIXER on output and assign to each channel 1 & 2 and 3
& 4 a deck. You should select the MIDI CTRL option in the mixer
panel if you want available the analog outputs. When we have
selected Mixer, the digital outputs of the sound card are directly
routed to the internal mixer and the analog outputs of the
equipment will have Master and Headphones. Remember that
channels 3 & 4 are accessible only on the front output for
headphones. To use inputs for time-code must change the option
INPUTS to a TIMECODES (If you are using a turntable, please be sure
you have selected phono).
Other configurations see the manual for your Virtual DJ.
Traktor
As with Virtual DJ, with Traktor we recommend installing ASIO
drivers for reducing latency. The following explains how to
configure the outputs in case you do not use ASIO drivers:
Select Preferences / Audio Setup / SYNCRON Audio Device tab.
Select in Preferences/ Output Routing/ Mixing mode the Internal
option if the mixer panel is set to "MIDI CTRL" and External if we
have selected the Mixer option in the 4th option of the internal
menu.
In Output Monitor (Internal) or Output Deck B (External) must select
the "Speaker Out 2" output to the left channel and the "Out
Speakers 3" output to the right. In Output Master (Internal) or
Output Deck (External) must select "Speaker Out 0" outputs and
"Speakers Out 1" to the Left and Right channels, respectively.
With this configuration we have the master output on the rear
outputs of SYNCRON (Master balanced, unbalanced and Booth) and
Monitor output for the front headphone jack of SYNCRON.
NOTE: This output configuration is possible only for 1.2.7 Traktor
post versions. In lower versions without using ASIO drivers will only
have two outputs (1 stereo).
In Input Routing must select the "Microphone In 0" and "Microphone
In 1" on the Input Channel in which you want to make available the
entry. Without using ASIO drivers there is available only one input.
Then explain how to configure Traktor with the Akiyama ASIO
drivers in internal mixer mode.
Select Preferences / Audio Setup / Audio Device tab Akiyama ASIO.
Select in Preferences/ Output Routing/ Mixing mode the Internal
option if the mixer panel is set to "MIDI CTRL" and External if we
have selected the Mixer option in the 4th option of the internal
menu.
In Output Monitor (Internal) or Output Deck B (External), we must
select the 3th output to left channel and 4th output to right
channel. In Output Master (Internal) or Output Deck A (External)
must select outputs 1 and 2 for left and right channel respectively.