User guide

Taurus Super-S3 LCM Introduction
Page 2
1.4 Detailed View
1.4.1 Front View
LED/Button
Description
• Blue = Power on
HDD1/2
• Green = Data access (read/write)
•
Orange = Error or empty drive bay
Rebuild
•
Orange = Rebuilding data
Select
• Select setup menu or mode
OK
•
Confirm current setting or enter setup menu
Important
Before turning on the power, make sure the interface cable is connected and the computer is
running, otherwise the alarm goes off and the message [HDD Error or No Interface] is
displayed. However, it is normal for this message to appear for a few seconds when the unit is
switched on.
1.4.2 Rear View
Icon/Label
Description
• Security lock slot
eSATA
•
External SATA port
FW400
•
FireWire 400 port
FW800
• FireWire 800 port
USB 3.0
•
USB 3.0 SuperSpeed port
DC 12V
• Power receptacle
Power ON/OFF
To turn on the power, press and hold the
power button for 1 sec. and then release it.
To turn off the power, press and hold the
power button for 3 sec. and then release it.
Wait at least 5 seconds after turning off the
power, before turning it back on.