Owner manual

NT2 U3e Introduction
[1]
1 Introduction
1.1 System Requirements
1.1.1 PC Requirements
• Minimum Intel Pentium III CPU 500MHz, 128MB RAM
• Windows Vista, Windows 7
• Your hardware device must have the correct corresponding port (e.g. USB 3.0 host controller)
• eSATA host controller must support Plug & Play and Port Multiplier (Non-RAID only)
Note
For PC users, volumes larger than 2TB are only supported on Windows 7.
1.1.2 Mac Requirements
• Minimum Apple G4 processor, 128MB RAM
• Mac OS 10.4 or above
• Your hardware device must have the correct corresponding port and driver (e.g. USB 2.0).
• eSATA host controller must support Plug & Play and Port Multiplier (Non-RAID only)
1.1.3 Supported Hard Drives
• One or two 3.5" SATA-I, SATA-II or SATA-III hard drives
• 80GB - 3TB per HDD
• Hard drives of identical capacities are recommended
• Supports large volumes in excess of 2TB
Note
In order for the computer to access volumes larger than 2TB, both the hardware and OS need
to have the capacity to support large volumes (e.g. Windows 7 or Mac OS 10.4 and above).
1.2 Package Contents
Package content may vary depending on vendor & version.
• NT2 storage enclosure (hard drives not included)
• Power supply
• Interface cables
• User manual
1.3 About this Manual
Firmware, images and descriptions may vary slightly between this manual and the actual product
you have. Functions and features may change depending on the firmware version.
1.4 Trademarks
• MS-DOS, Microsoft, Windows Vista & 7 are trademarks of Microsoft Corporation.
• Apple Macintosh and Mac are trademarks of Apple Computer.
• All other third party brands and names are the property of their respective owners.