Specification
Installations (refer to Page 4 for parts):
Measure the distance between stove top and the bottom of
range hood. A distance of 30” to 36” is recommended*.
*Due to different ceiling height congurations, recommend-
ed height may not be applicable.
Installation of Metal Liner Inserts
1. Due to the weight of the assembly three people may be required for proper installation.
2. Install screws through the pre-drilled EZ mount holes into the decorative hood structure. Tap chrome cap into
EZ mount holes for ush appearance See Figure 1.
3. Additional mounting fasteners may be used to secure to the back wall and top (from inside).
CAUTION: Make certain the range hood is secure before releasing!
4. For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
5. Use 8” round steel pipe (follow building codes in your area) to connect the exhaust on the hood to the duct-
work above. Use silver tape or duct tape to make all joints secure and air tight. Refer to Figure 2.
SAFETY WARNING: Risk of electrical shock. this range hood must be properly grounded. Make sure this
is done by qualied electrician in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally.
6. Connect the range hood to a designated standard outlet or cut off the plug and connect three wires (black,
white and green) to house wires and cap with wire connectors. Connect according to colors (i.e. black to
black, white to white, and green to green) as shown in Figure 3.
7. Store excess wires in the wiring box.
8. Drop oil tunnel into recess support near rear of hood. Refer to Figure 4.
Installation
Figure 1
Wood Hood
Mounting Holes
Page 10