Specification
Page 9
Preparation
WARNING
Severe Injury
Rotating fan can cause severe
injury. Stay clear of fan when
motor is running.
WARNING
Excessive Weight
Require three or more person to move and
install this range hood. Spinal or other bodi-
ly injuries could occur if it is not followed.
Advanced Preparations:
Be familiar with the controls of the range hood by reading1.
through Range Hood Operations, Page 12.
Place the range hood on a at, stable surface. Connect the2.
range hood to a designated standard outlet (please refer the
product label for the suitable voltage of this unit) and turn on
the range hood. Verify all operations of the range hood by
referring to Range Hood Operations, Page 12.
Place all supplied parts and required hardware on a at, stable surface and3.
verify the existence of all supplied parts listed on Page 4.
Carefully remove the white plastic protective coat from the chimney covers4.
and range hood.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Decide the location of the venting pipe from the hood to the outside. Refer to 1. Venting Methods on Page 7.
Due to the weight and size of this unit, please make sure that the wood hood or framework being used is stable2.
and secure in the wall. A straight, short vent run will allow the hood to perform more efciently.
Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the3.
hood.
IMPORTANT: Peel white plastic protective coat off the hood, if any.4.
Use silver tape or duct tape to seal joints between pipe sections.5.
Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt. Remove6.
any hazardous objects around the area when installing.
CAUTION: If moving the cooking range is necessary to install the hood, turn OFF the power on an elec-
tric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
The hood assembly is equipped with the standard 8” round vent.7.
If venting to the outside install vent system (see 8. Venting Requirements, Page 6). Use caulking to seal exterior
wall or roof openings.
Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall. Leave approxi-9.
mately 12” of electrical cord hanging from the ceiling. Do not restore power until wiring is completed.
Disconnect power cord, remove the bufe lters and the grease tunnel. Refer to installation step 9 & 10.10.
Reinstall the bafe lters and the grease tunnel after the range hood is properly installed.11.