Installation Guide

Sink Drain
With Removeable Strainer
Installation Instructions
EX: E003005T Rev: A
１
２
1. Remove the filter from the drainer, and then
screw out the ferrule with a screwdriver to
separate the filter flange from the drainer body.
2. Place the filter flange into the sink, making
sure the thin rubber gasket is in place.
3. Lubricate flange gasket with water, place
into lip of drain body and position drain body
on the sink bottom.
Installation
Model: 82101
4. Align the ribs on the drain body and filter
flange, then screw in ferrule and tighten
with a screwdriver.
Questions, problems, missing parts?
call Akicon Customer Service 8 a.m.-6p.m. EST, Monday-Friday
Phone: [phone], Email: [e-mail]
AKICONSHOP.COM
• Maximum diameter of drain flange: 4-13/32"
• Specification for drain nut: 2" (minimum thread
diameter about 2-1/4")
5. Push strainer into ferrule in drain body.
6. Make sure washer is in position, slide nut
on 2" drain tubing and hand tighten the
drain body nut. Test for leaks.
Thin rubber gasket
Strainer flange
Sink
Flange gasket
Drain body
Sink
Ferrule
Sink
Strainer
Sink
Strainer
Drainer
Sink
Washer and
Nut and
Drain tubing
(Not supplied)