Installation Guide

2
Insert spout assembly through the second hole of sink, then
from underneath sink, place Installation assembly onto thread
pipe and tighten with Mounting nut, then tighten adapter
connector using wrench, be sure the adapter connetor is in the
parallel status.
Insert spout assembly through the second hole of sink, from
underneath sink, place Installation assembly onto thread pipe
and tighten with Mounting nut, then tighten adapter connector
using adjustable wrench, be sure the adapter connetor is in
the parallel status.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Fig. 1
Sink
CAUTION
Always turn off water and relieve pressure before working on your faucet.
PREPARATION
Clean the dirt from valve outlets. Turn off the water supply valves. This is usually found near the water meter.
If you are replacing an existing faucet, remove the faucet from the sink, and clean the sink surface thoroughly.
Estimated Assembly Time: 20 minutes
Helpful Tools: (not included)
PTFE plumber’s tape or thread sealant Flathead screwdriver Phillips screwdriver
Pliers
Adjustable wrench
Cloth
Your installation may require supply lines and/or shut-off valves, cone washers, friction rings, or other additional tools.
Consult the store where your faucet was purchased for connections that may be required for your area.
3
MAINTENANCE AND CARE
After installation is complete, remove aerator and rotate
handle to the closed position. Turn on the water supply
valves, and check all connections for a leak. Turn on your
faucet and allow both hot and cold water to run at least one
minute each, then Install the Aerator.
Connect spout hot water supply line to the left control valve assembly,
connect spout cold water supply line to the right control valve assembly,
then tighten nut.
Use the water supply line to connect the control valve assembly to the
hot water and cold water supply valve separately (the supply line is
purchased separately) and tighten the supply line nut.
Insert spray hose down through spray seat, then connect the spray
hose to the lower end of the nozzle assembly and tighten it.
Turn off water and relieve pressure before working on your
f
aucet! Pull out the button at the top of the handle, screw the
screws out with a cross screwdriver, pull out the handle and
unscrew the cover, unscrew cartridge and inspect it, replace
parts as necessary. Reassemble parts by reversing steps.
1. Faucet Start Up
3.
2. Handle and Valve Removal
To maintain the faucet, clean frequently and regularly.
Clean with clear
water or mild liquid, rinse with clear water, and then dry with soft cotton cloth.
Do not use any abrasive cleansers, cloths, or paper towels.
Do not use any acid or abrasive detergent.
Fig. 2
Washer
Fig. 3
Cold
Hot
Washer
Washer