Installation Guide

Turn off water and relieve pressure! Detach handle button

using a small flathead screwdriver, unscrew set screw

using Allen Wrench and take off handle.

Remove handles. Unscrew Dome Cap counter clockwise

by hand. Unscrew Retaining Nut using adjustable wrench,

take out cartridge assembly and inspect. Replace parts

as necessary. Reassemble parts by reversing steps.

Handle Removal Maintenance Valve Cartridge Removal Maintenance

INSTALLATION PROCEDURES

You should clean all the dirts from valve outlets.

Turning off the water supply valves. This is usually

found near the water meter. If you are replacing

an existing faucet, remove the faucet from the

sink and clean the sink surface thoroughly.

Install without Deck Plate. Make sure the O-RING

is placed onto the bottom of Base Ring. Install

faucet through hole in sink. From underside sink,

put Plastic Washer and Mounting Nut. Position

faucet on sink properly and tighten Mounting Nut.

If necessary, tighten screws using a adjustable

wrench until the faucet is firmly connected to the

sink.

1 2

If necessary, tighten screws using a adjustable

OPEN