Installation Guide

3
Lift the handle up, the cartridge will be activated
allowing water to flow. The water flow will increase
by continuing to rotate handle. By rotating the
handle to the right, the water temperature will
decrease to cold flow only. By rotating Handle to
the left, the water temperature will increase to hot onl
.
76
Close
Open
Hot
Cold
Faucet Start Up
Connect hot and cold water supply lines to the Water
Supply Valves.
4
INSTALLATION PROCEDURES
You should clean all the dirts from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING
is placed onto the bottom of Base Ring. Install
faucet through hole in sink. From underside sink,
put Plastic Washer and Mounting Nut. Position
faucet on sink properly and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
2
1 2
3
Install with Deck Plate.
Make sure the O-RING is placed onto the bottom
of Base Ring. Install faucet through Deck Plate.
From underside sink, put Plastic Washer and
Mounting Nut. Position faucet on sink properly
and tighten Mounting Nut.
2A 2B
Unscrew Locknut. Make sure the Rubber Washer in
the right position under Flange. Insert Pop-up
Assembly into Sink drain Hole. From underneath,
tighten with Lockset.
Press stopper to keep or release water.
5A 5B
Cold
Hot