Installation Guide

9
4. Mount the fan housing (A) to joist using the long wood
screws (AA) on both sides.
Hardware Used
AA
Long wood screw
x 4
eht lluP .)1.5( revoc xob gniriw evomeR .5 house wires
through the wire box cover hole. Using a quick connector,
secure 120 V AC house wiring from the wall switch to the
fan as shown in the wiring diagram on page 5. 14 AWG
is the smallest conductor that should be used for branch-
circuit wiring.
gniriw eht otni kcab seriw detcennoc eht hsup ylluferaC
box housing. Reattach the wiring box cover (5.1).
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult
an electrical contractor to determine safely.
eruces dna )dedulcni ton( )1.6( tcud .ni 4 ralucric a llatsnI .6
it with duct tape or clamps (neither included).
Finish ceiling work. Ceiling hole should be aligned with edge
of fan housing (A).
7. Plug the fan motor plug into the fan housing(4 hole to 4
hole). Plug the LED light panel plug into the housing as
well.(2 hole to 2 hole)
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
4
6
5
7
AA
A
joist
Ceiling board
Quick connector
House wires
Product wires
5.1
6.1
2 hole
NIGHT LIGHT
L2
4 hole
2 hole
LIGHT
L1
NIGHT LIGHT