Specifications

Installed
Sound
GN 30 (50) MINIJACK
SPECIFICATIONS
Bass roll off filter: 250 Hz, -10 dB at 50 Hz
Electrical impedance: ≤600 ohms
Recommended load impedance: ≥2,000 ohms
Power requirement: 9 to 52 V phantom power to DIN 45596
Current consumption: ≤3 mA
Connector: 3-pin male XLR
Finish: matte dark grey
Size: max. dia.: 20 mm (0.8 in.)
length: 305/500 mm (12/20 in.)
Net/shipping weight: 110/522 g (3.9/13.9 oz.)
120/495 g (4.2/17.5 oz.)
Standard accessories: DPA phantom power adapter, HCS
Optional accessories: MK 9/10, N 62 E, N 66 E, SA 60, ST 45
Item numbers
GN 30 Minijack 2765Z0036
GN 50 Minijack 2765Z0037
• Gooseneck with screw thread and mini jack
• Installation module with permanently soldered
remote phantom power adapter
• 30 or 50 cm length
• Extra large LED ring
• Highly reliable contacts for capsule modules
• Integrated switchable bass cut
The GN Minijack System makes installing and taking down
goosenecks even quicker than before. The HCS mounting
flange is built into the table. The permanently soldered
phantom power adapter can be fastened to the underside
of the tabletop by means of a clamp. The entire wiring
remains invisible. The goosenecks can be mounted and
taken down quite easily as required, while the integrated
mini jack ensures perfect contact reliability.
The LED ring can be powered directly. Depending on the
microphone status, it an be activated and deactivated by
a logic circuit (e.g., the logic out on an AS 16 x 12 auto-
matic mixer), showing clearly which of the microphones
are active.
Each kit comprises a GN 30 (50) CS, an HCS support, and
a permanently connected DPA phantom power adapter.
GN 30 CS GN 50 CS
DPA HCS
119119
7496_04_Fulline_E2_fsch 29.06.2004 13:29 Uhr Seite 119