User's Manual

3 Setting Up
3.8.3 Selecting Frequencies
from the Preset Screen
Diagram 5: Setting frequencies
manually.
3.8.4 Editing the Receiver
Name
Note:
Diagram 6: Editing the receiver
name.
3.9 Setting Up the Transmitter
Note:
3.9.1 Frequency
Refer to figs. 3 and 4.
Use  and  to select the desired
Preset.
Use  and  to select the desired
Frequency Group.
Use  and  to select the desired fre-
quency as a Subchannel of the selected
Frequency Group.
SAVE >Y<: save your setting.
SAVE >N<: reject your setting.
This screen lets you edit the current name of the receiver. If you have stored no name for the receiver yet
or deleted its previous name, this screen will not be available. The EXTRA screen, however, allows you
to save a new name at any time (refer to section 4.1.3).
The receiver name may be any combination of up to six letters and/or numbers.
Use  and  to select the first charac-
ter.
Use  and  to select the second
character, etc….
… to the sixth character.
SAVE >Y<: save your setting.
SAVE >N<: reject your setting.
>DELETE<: delete all names.
Section 3.9.1 applies to both the HT 400 handheld transmitter and the PT 400 bodypack transmitter. To set
the audio input gain on the HT 400, use the TX Gain screen on the receiver and the infrared connection.
To set the audio input gain on the PT 400, use the gain control in the transmitter battery compartment.
To program the transmitter for the same frequency you selected on the receiver:
1. Switch power to the receiver on.
2. Set the ON-MUTE/PRG-OFF switch (19) on the transmitter to "OFF". The status LED (20) will extin-
guish.
25
WMS 400
"AT 3.0 02"
FREQ
"750.000"
FREQ MHz
Preset
>PRG IR<
IR
>GROUP<
" >3.0<"
>CHANNEL<
" >01<"
SAVE >N<
>FREQ<
SAVE >Y<
>FREQ<
>NAME<
" >AT<"
3.9
NAME
"DIANE"
NAME
"DIANE"
NAME
" J>I<ANE"
NAME
"
>JONI_ _<"
SAVE >N<
>X-TRA<
EXTRA
X-TRA
>DELETE<
>X-TRA<
SAVE >Y<
>X-TRA<
NAME
" >D<IANE"
NAME
" JOANIE"