User's Manual

Category:
External
Product/Project:
INSTALLATION
Page:
6 (12)
Subject:
INSTALLATION MANUAL SESAM 6099 TRANSMITTER
Document ID:
939045-000
Date:
2008-01-18
Written by:
Henrik Ring
Checked by:
Anders Modig
Approved by:
Henrik Ring
Version:
A1
ÅKERSTRÖMS BJÖRBO AB, SE-780 45 BJÖRBO, Sweden
Phone [phone], Fax [phone]
Vat No SE556153982501 Registrated office BJÖRBO
www.akerstroms.se
4. General description
The Sesam 6099 transmitter is a
flexible multi-purpose transmitter
designed for applications where a 3-
digit number (0-999) are to be
transmitted in combination with up to
six separate functions.
All transmitters have a 32-bit
addressing scheme in addition to a
unique 16-bit serial number.
5. Buttons and switches
The Sesam 6000 is equipped with a
number of buttons and switches as
described in Fig. 1
B1-B3 Function buttons 1-3
B4-B6 External function buttons. If the
transmitter is fitted with only one
external button it is assigned B5.
SW1 – Frequency channel selector
The frequency is set by the 8-pole DIP-switch according to the frequency selection table.
Only the available settings in the table should be used.
SW2 - Sub-ID selector
A sub-ID can be set in the transmitter by using an internal DIP switch (SW2). The sub-ID is a part
of the data packet output on the Sesam 6000c receiver RS-232 port. The SW2 DIP switch setting is
normally not used by the receiver and is left to be processed by an external PLC.
The DIP switch setting is represented in the data packet as a 16-bit integer and is the sum of all DIP
switch settings. The value of each switch is shown in Fig. 2
Note! If OEM program mode 1 is selected on the transmitter
the SW2 settings are ignored and the transmitter serial
number is used as the sub-ID instead. See Transmitter
Configuration Menu section.
Fig. 1 Transmitter layout and switch locations
729 243
486
81
162
27
54
12345678
+
-
0
2187
4374
1458
9
18
3
6
1
2
Fig. 2 Sub-ID DIP switch SW2