User's Manual

Replacing batteries in the transmitter 14 (16)
Sesam 800 K3 RXDIN USA Manual Document-ID: 946415-000
Version: A0 Author: SH
10 Replacingbatteriesinthetransmitter
10.1 ReplacingbatteriesinSesamK3
If the indication LED on the transmitter indicates low battery, replace the batter-
ies promptly. Before changing the batteries note that changing of batteries must
take place in a clean environment free from static electricity.
The batteries are changed as follows:
1. Open the battery cover by unscrewing the 3 screws on the backside of the
transmitter housing (see g. 5).
2. Carefully remove the cover.
3. Remove the batteries.
4. Insert the new batteries (see g. 6 and 7).
5. Close the cover.
6. Tighten the 3 screws with PH00 (torque 0,14 Nm).
Figure5. Battery cover
Figure6. Insertthebatteriesinthe
transmitter
Figure7. Batteries in its correct
position