User's Manual

Conguration of the receiver 12 (16)
Sesam 800 K3 RXDIN USA Manual Document-ID: 946415-000
Version: A0 Author: SH
8.2 Advancedconguration
This conguration allows the user to determine which button activates a specic
relay.
1. Open the lid on the receiver, see basic conguration.
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
a. Press the Learn/Erase button once in order to select relay one (the status
LED will ash once).
b. Press the Learn/Erase button twice in order to activate relay two (the
status LED will ash twice).
c. Press the Learn/Erase button three times in order to activate relay three
(the status LED will ash three times).
3. Press the button that shall be used for activating the selected relay in the
receiver. If the conguration is accepted by the receiver, LED 7 ashes 3
times.
4. Mount the lid on the receiver, see basic conguration.
8.3 Erasingalltransmittersinthereceiver
1. Open the lid on the receiver.
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
3. Press the Learn/Erase button for 5 seconds (until LED 7 is OFF). All trans-
mitters are now erased from the receiver memory.
4. Mount the lid on the receiver.