Installation Guide

ManualsBrandsAKDY ManualsBath65 in. 8-Jet Rainfall Shower Panel System with Waterfall Shower Head and Shower Wand in Black Painted Stainless Steel

Installaon Manual

All-In-One Shower Panel System

Office: +1 (888) 808-0450

Email: help@akdyusa.com

Distributed by akdyusa.com

Manufactured by AKDY

FOR RESIDENTIAL USE ONLY IN US & CA

WARRANTY VOID OUTSIDE US & CA

Revised 08/16

Summary of content (8 pages)

PAGE 2
A. Direct Connect Instructions IMPORTANT: In order to install this shower panel, simple understanding of plumbing techniques will be necessary. Please contact a professional plumber if you are unfamiliar with plumbing techniques or require assistance. Prerequisites:  separate cold and hot water supply lines NOTE: This shower panel replaces any mixing valve you are currently using. Step 1 Thank you for your purchase of an AKDY all-in-one shower panel.
PAGE 3
A. Direct Connect Instructions Step 3 Using a drill, attach the wall mounting brackets with the included hardware. An extra set of hands may be required for the following steps. Lift and locate the hot and cold water lines on the shower panel (red circle). Step 4 Connect the hot and cold water supply lines to the flexible hoses. Be sure to use the included washers. It is recommended a ⅜” right angle connection be installed to better route the flexible hoses (see diagram).
PAGE 4
B. Easy Connect System Instructions Step 1 Before beginning installation, ensure the shower panel has sufficient space between the showerhead and pre-existing temperature controls. Step 2 With the water turned off, remove your showerhead and arm from the wall. Note: Standard 1/2” connections are used.
PAGE 5
B. Easy Connect System Instructions Step 3 Connect the included Brass Extender Joint (1/2” size) to the existing showerhead pipe outlet. Multiple sized brass extenders may be included. Choose the one appropriate for your wall thickness. Use Teflon tape for a secure seal. Step 3a Peel off the adhesive backing from the Base Plate Cover. Step 3b Adhere the Base Plate Cover to the wall. Note: Make sure the wall surface is free of dirt and residue.
PAGE 6
Mounting Instructions: Type A
PAGE 7
Mounting Instructions: Type B
PAGE 8
Use and Care Guide Shower Panel Body Acrylic or tempered glass shower panels may show water spots. A mild household cleaner will remove them. Aluminum or stainless steel shower panels can be cleaned with a mild cleaner. Note: Avoid abrasive cleaners or harsh scrubbing pads (acetone, Ajax, Comet, or other solvents). Showerhead and Body Jets Both the showerhead and body jets use non-clogging rubber nozzles that can remove calcium deposits just by rubbing your finger along them.