INSTALLATION MANUAL Single Handle Pull-down Kitchen Faucet KF0007 KF0008 KF0009 KF0010 KF0011 KF0012 Customer Service Phone: 1.888.808.
Prior to Installation: • Make sure you have all necessary parts by checking the diagram and parts list.
KF0007 | KF0008 | KF0009 Diagram and Parts List 1. Spray Head 2. Faucet Body 3. Hot and Cold Waterlines A. Cold B. Hot 4. Quick Connector 5. Mounting Hardware 6. 7. 8. 9. A. Rubber Washer B. Metal Washer C. Mounting Nut D.
KF0007 | KF0008 | KF0009 Faucet Installation Procedure Installer Tip: Shut off main water supply before installing new faucet.
KF0007 | KF0008 | KF0009 Step 1. Faucet installation - without deck plate Insert Base O-ring. Step 2. Install faucet and mounting hardware Insert faucet body (2) into hole in countertop or deck plate assembly. Install mounting hardware (8, 5A, B, C & D) from underneath the countertop.
KF0007 | KF0008 | KF0009 Step 3. Secure mounting hardware Adjust direction of faucet body (2) so that handle is on right side of faucet. Tighten mounting nut (5C) until snug. Tighten mounting screws (5D) to nut with a Phillips screwdriver until snug. Step 4. Attach spray hose and counterweight Connect spray hose (6) to quick connector (4) attached to supply line. Install weight (7) on lowest vertical point on spray hose (6).
KF0007 | KF0008 | KF0009 Step 5. Connect waterlines Connect waterlines (3) to angle stops. Tighten both ends of hose with a wrench until snug. Turn on hot and cold angle stops and check for leaks. NOTE: Make sure filter washers are installed. Step 6. Flush spray hose Un-screw spray head (1) from spray hose (6). Hold tip of spray hose (6). Turn faucet on and let the water run for 60 seconds to flush any debris.
KF0007 | KF0008 | KF0009 Step 7. Check for leaks Check for leaks at the connections. Retighten if necessary.
KF0010 | KF0011 | KF0012 Diagram and Parts List 3B
KF0010 | KF0011 | KF0012 Diagram and Parts List 1. Spray Head 2. Faucet Body 3. Hot & ColdWaterlines A.Cold B.Hot 4. Nylon braidedhose 5. Mounting Hardware A.Rubber Washer B.Metal Washer C.Mounting Nut D.Mounting Screws Tools you will need Adjustable Wrench Silicone Sealant (optional) 6. Cambox 7.
KF0007 | KF0008 | KF0009
Codes/Standards Applicable: LEAD FREE IA PM OR &T Meets ASME A112.18.1M/A112.18.1 1.75GPM 6.6L/min maximum TM Care & Maintenance *To keep the product clean & shining, follow the steps below: 1. 2. 3. Rinse with clean water & dry with a soft cloth Do not clean with soaps, acid, polish, abrasives, or harsh cleaners Do not use cloth with a coarse surface *This installation manual is subject to change without further notice.
