User manual

9
NOTE:
The SATA connection of the enclosure is only avaliable with SATA HDD installed
and it is not supported under Windows 98.
Motherboard or adapter card with SATA interface is required. Make sure the SATA
interface driver is installed and SATA port enabled in BIOS.
Before using the external SATA connection the USB2.0 / eSATA switch must be in
the eSATA position.
Windows OS XP/2003/2000/Me
1. Make sure the computer system is switched off.
2. Connect the INTEGRAL drive to the motherboard SATA port with the supplied SATA cable.
If the SATA port is not apparent consult the motherboard manual.
To avoid continues opening the case we recommend Akasa ALLINONE panel, which provides external SATA port.
3. Connect the supplied power pack and switch on your enclosure.
4. Make sure the slide switch on the INTEGRAL enclosure is in the ESATA postition.
5. Boot-up your computer into Windows O/S.
6. Open “My Computer” to see your INTEGRAL eSATA drive as a local disk rady to use.
Mac OS10.2 or higher
1. Make sure the computer system is switched off.
2. Connect the INTEGRAL drive to your motherboard SATA port with the supplied SATA cable.
3. Connect the supplied power pack and switch on your enclosure.
4. Make sure the slide switch on the INTEGRAL enclosure is in the ESATA postition.
5. Boot-up your computer into MAC O/S.
6. MAC system will automatically recognize and mount on your desktop ready to use.
ESATA CONNECTION
Serial ATA Connection
Connecting the INTEGRAL eSATA (eSATA mode)
Disconnecting the INTEGRAL eSATA (eSATA mode)
1. Turn off the system
2. Switch off and unplug the enclosure
Drivers Installation
INTEGRAL eSATA drive is recognized as a local
drive and is supported by motherboard SATA
driver. You do not need to install any additional
drivers.
NOTE:
Do not connect both (USB and ESATA) cables at the same time.
WARNING!
Do not switch off the enclosure or unplug the SATA or power cable when using the INTEGRAL eSATA .DOING
THIS MAY RESULT IN LOSS OF DATA!