User manual

4
Harddisk Installation
1.
Open the back of the enclosure by undoing
the securing screws and sliding the tray out
of the aluminium housing.
NOTE: Disconnect the LED cable before
completely sliding it out.
3.
Place the HDD in the tray aligning the IDE
and power connectors. Connect the IDE and
power connectors to the HDD.
2.
Write down the ID number and WRITE
KEY before closing the enclosure. It will
be needed in later stages of the network
installation.
4.
Position the HDD in the tray so that the
mounting holes on the HDD line up with the
tray mounting holes. Use the four mounting
screws to secure the HDD in the tray.
POWER
CONNECTOR
IDE
CONNECTOR
LED
CABLE
Harddisk Installation