Safety data sheet

Page 4/8
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 11.02.2015 Revision: 11.02.2015Version: 1
Product name: Tim-Clean
(Contd. of page 3)
40.1.0
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be monitored at the
workplace.
·
DNELs
5989-27-5(R)-p-mentha-1,8-diene
Oral DNEL acute-systemic 4.76 mg/kg human/day (consumer)
Inhalative DNEL Acute-systemic mg/m3 33.3 mg/m3 (worker)
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
·
Respiratory protection:
Use suitable respiratory protective device only when aerosol or mist is formed.
·
Protection of hands:
Protective gloves
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from
manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not
be calculated in advance and has therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
The determined penetration times according to EN 374 part III are not performe d under practical conditions. Therefore a
maximum wearing time, which corresponds to 50% of the penetration time, is recommended.
·
For the permanent contact gloves made of the following materials are suitable:
Nitrile rubber, NBR
PVA gloves
·
Not suitable are gloves made of the following materials:
Strong material gloves
·
Eye protection:
Goggles recommended during refilling
·
Body protection:
Solvent resistant protective clothing
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Liquid
Colour:
Colourless
·
Odour:
Characteristic
·
pH-value:
Not applicable.
·
Change in condition
Melting point/Melting range:
Undetermined.
Boiling point/Boiling range:
> 200 °C
·
Flash point:
> 55 °C
·
Flammability (solid, gaseous):
Not applicable.
·
Ignition temperature:
230 °C
·
Decomposition temperature:
Not determined.
·
Self-igniting:
Product is not selfigniting.
·
Danger of explosion:
Product does not present an explosion hazard.
(Contd. on page 5)
GB