Operator`s manual

104Chapter 15 Connecting the MPC500 to your computer
MPC500 Operator's Manual rev 1.0
2. Connect the MPC500’s USB slave jack to your computer’s USB host jack via USB cable.
Removable media will be displayed on the desktop.
3. To save the data in the computer, select the data and drag and drop it from the removable disk to the hard disk. To
load the data from the computer, select the data and drag and drop it from the hard disk to the removal media.
4. After you finish the data transfer, select the removable media and drag and drop to the trash can.
When you drag the removal media to the Dock’s recycle bin under Mac OS 10.x, the icon will change to the eject icon.
5. Remove the USB cable from the USB jacks of the MPC500 and the computer.
Note: Make sure that you do Step #4 before disconnecting the USB page.
Note: You can transfer the data between the MPC500 and the computer only when the USB page is displayed. You can not move to another
page or mode from USB page unless you disconnect the USB cable.