Operation Manual

CD PELAYER
Swi tch ing on/off: Sav e energy
Whethe r yo u ar e using mai ns or battery
supply,toa vo id un necess ar y en er gy
consumpt ion al way s ad jus t the source
selec tor to of f.
General operation
1 . To select your sound source adjust the
source selector to CD.MP3/OFF/FM/AM. CD/ OFF/FM/AM.
2 . Adjust the sound with the VOLUME
controls.
3. To switch off the set, adjust the source
selector to off position.
RADIO
Radio reception
1. Slide the FUNCTION selector to FM/AM.
2. Rotate the TUNING control to find
the desired stations.
3. When you have finished listening, slide
the FUNCTION selector to the OFF
position.
BASIC FUNCTIONS RADIO
EN-4 EN-5
–
–
For FM, pull out the telescopic antenna. Incline
and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
For AM the set is provided with a built-in antenna
so the telescopic antenna is not needed.
Direct the antenna by turning the whole set.
Reviewing your set program
After playing at least one programmed
track,press or , the display will
show your stored track numbers
Erasing a program
You can erase the contents of the
memory by:
- opening the CD door;
- Slide the function selector to Radio or
OFF mode;
- In the STOP mode, press PROG and
then press STOP.
Notice for CDR/CDRW users:
Depending on the type of CD burner, on
the disc brand and the burning speed,
some reading problems may occur.
CD Player
Playing a CD/Mp3
This CD-player can play Audio Discs, CD-R
andCD-Rewritable.Do not try to playCD-ROM,
CDi, VCD, DVD or computer CD.
1. Adjust the source selector to CD.
Display: shows “- -” Briefly.
2. To open the CD door, press the CD door at
the edge marked OPEN.
3. Insert a CD , CD-R or CD-RW with the
printed side facing up and press the CD door
gently close.
4. Press PLAY/PAUSE on the set to start play
back.
5. To pause playback press PLAY / PAUSE to
resume, press PLAY/PAUSE again.
6. To stop CD playback, press STOP
7. In MP3 playing mode, press "logo " STOP/
Note: CD play will also stop when:
- you open the CD compartment;
- you select RADIO sound source;
- the CD has reached to the end.
Selecting a different track CD/Mp3
During playback you can use or to select a
particular track.
If you have selected a track number in the stop
or pause position , press PLAY/PAUSE to
start playback.
Press once briefly for the next track, or
press repeatedly until the desired track number
appears in the display.
Press once briefly to return to the beginning
of a current track.
Press more than once briefly for a previous
track.
Different play modes: Repeat
- REPEAT 1 > REPEAT ALL > NORMAL
- REPEAT 1 > REPEAT ALBUM > REPEAT ALL > NORMAL
CD PLAYER
FOLDER to select the desired Album.
CD MODE :
MP3 MODE :
You can program up to 20 titles in arbitrary
sequence. You can also program a
title more than once.
1. Before programming always press
STOP and then press PROG.
On the display you can see
„P01“ and „PROG“ blinking.
2. Use / SKIP REV. or /
SKIP FWD. to select a desired title.
3. Press „PROG.“ once to store the
title. The indicators „P“ and „PROG“
are blinking on the
display. Please select the next title.
4. Repeat steps 2 and 3 to store further titles.
5. Press PLAY/PAUSE to start
playback of the programmed titles.