Instruction Manual

After Sales Support

(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support

Installation

• Heavy: This appliance is heavy, take care when moving it. To avoid back or other

injury, consider a two person lift or mechanical aid when installing it. Failure to do

so can result in back or other injury.

• WARNING: Ventilation: To ensure proper ventilation, keep any ventilation

openings, in the appliance enclosure or in the built-in structure, clear of

obstructions. Ensure adequate air circulation around the appliance to prevent

overheating.

• Level: Install the appliance level in order to ensure proper operation. Please refer to

page 8 for levelling instructions.

• Location: Install the appliance in an area that meets the following requirements:

— Ambient temperature: The ambient temperatures must correspond to the

climate class (T) indicated on the rating plate of the appliance: 18 °C – 43 °C.

— Floor surface: The floor must be sturdy, level and strong enough to support the

unit when it is fully loaded.

— Areas to avoid: Avoid areas where the appliance would be exposed to direct

sunlight, sources of heat (stove, heater, radiator, etc.), extreme cold ambient

temperatures or excessive moisture and high humidity (such as outdoors or

exposed to wind, rain water spray or drips). Installing it in the coolest area of the

room will save energy consumption and running costs.

Cleaning and maintenance

• Disconnect: Unplug the appliance before cleaning or servicing. Failure to do so can

result in electric shock, injury or death. Do not connect or disconnect the plug when

your hands are wet.

• Flames: Do not let open flames or ignition sources enter the appliance.

• Flammable/explosive substances: Never clean this appliance with flammable

fluids. Do not store or use volatile, flammable or explosive substances such as

aerosol cans with a flammable propellants in or close to this or any other appliance.

The fumes can create a fire hazard or explosion.

• Solvents: Do not use solvent based cleaning agents or abrasives on the interior as

these may damage or discolour the surfaces of the appliances.

• WARNING: Do not use mechanical devices or other means to accelerate the

defrosting process, other than those recommended by the manufacturer. Never use

a sharp or metal instrument to remove frost or clean the appliance. Use a plastic

scraper, if necessary.

• Service: Do not attempt to repair, modify or replace any part of the appliance unless

specifically recommended in this manual. Refer all other servicing to a qualified

technician, or contact the after sales support centre for advice.

Important Safety Instructions (Cont.)