Instruction Manual

8
8
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Installation
• Clearances: Allow at least 50mm clear space between the back and sides of the
unit and your wall or another appliance - and 300mm between the top of the unit
and the ceiling or top cabinet - to ensure proper air circulation, which is necessary
to allow for the cooling of the compressor and condenser (Fig.1).
Getting Started (Cont.)
• Location: Locate the bar fridge:
• On a firm and completely flat surface. Put a heat-proof base under the appliance
to block heat emission if you need to locate this appliance on carpet.
• Away from direct sunlight, which may affect the coating.
• Away from sources of heat (stove, heater, radiator, etc.), which may increase
power consumption.
• In an area without extreme cold ambient temperatures, which may affect cooling
performance.
• In an area without excessive moisture and high humidity.
• In an area where there are no obstructions that could prevent the fridge door from
closing.
• Positioning: make sure all adjustable legs are on the floor, and set the appliance to
slope slightly backwards to keep the doors closed tightly. For more on levelling this
appliance, see page 9.
• Enhancing energy efficiency: Installing the unit in the coolest area of the room will
save energy consumption and running costs.
• Before plugging in your new bar fridge, let it stand upright for approximately
2 hours. This will allow the refrigerant gases to settle into the compressor and
reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Electrical connection: Plug the unit into an exclusive, properly installed and
earthed wall outlet. Do not under any circumstances cut or remove the third (ground)
prong from the power cord. If in doubt about your setup, direct any questions
concerning power and/or grounding to a certified electrician.
Fig.1
300mm
50mm
50mm
50mm