Instruction Manual

After Sales Support

(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support

Important Safety Instructions (Cont.)

• WARNING! Do not use any electrical appliances (such as ice cream makers)

inside refrigeration appliances, unless they are approved for this purpose by the

manufacturer.

Cleaning and maintenance

• Disconnect: Unplug the appliance before cleaning or servicing. Failure to do so can

result in electric shock, injury or death. Do not connect or disconnect the plug when

your hands are wet.

• Flames: Do not let open flames or ignition sources enter the appliance.

• Flammable/explosive substances: Never clean this appliance with flammable fluids.

Do not store or use volatile, flammable or explosive substances such as aerosol cans

with a flammable propellants in or close to this or any other appliance. The fumes can

create a fire hazard or explosion.

• Solvents: Do not use solvent based cleaning agents or abrasives on the interior as

these may damage or discolour the surfaces of the appliances.

• WARNING! Do not use mechanical devices or other means to accelerate the

defrosting process. Never use a sharp or metal instrument to remove frost or clean the

appliance. Use a plastic scraper, if necessary.

• Service: Do not attempt to repair, modify or replace any part of the appliance unless

specifically recommended in this manual. Refer all other servicing to a qualified

technician.

Installation (see page 8 for more installation instructions)

• Heavy: This appliance is heavy, take care when moving it. To avoid back or other injury,

consider a two person lift or mechanical aid when installing it. Failure to do so can result

in back or other injury.

• Freestanding design: This appliance is designed to be freestanding only and should

not be recessed or built in.

• Keep it upright: Do not tilt the fridge more than 45º from upright when moving it.

• Handle with care: Do not apply force to any part such as the condenser or door.

• WARNING: Ventilation: To ensure proper ventilation, keep any ventilation openings,

in the appliance enclosure or in the built-in structure, clear of obstructions. Ensure

adequate air circulation around the appliance to prevent overheating.

• Level: Install the appliance level in order to ensure proper operation. If necessary,

adjust the levelling legs at the bottom of the unit.

• Location: Install the appliance in an area that meets the following requirements:

- The floor must be sturdy, level and strong enough to support the unit when fully loaded.

- Avoid areas where the appliance would be exposed to direct sunlight, sources of

heat (stove, heater, radiator, etc.), extreme cold ambient temperatures or excessive

moisture and high humidity (such as outdoors or exposed to wind, rain water spray or

drips). Installing it in the coolest area of the room will save energy consumption and

running costs.