Instruction Manual

13
13
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
FAQs and Troubleshooting Guide
Problem Possible cause
The fridge does not
operate.
It is not plugged in. Ensure it is properly plugged
in and there is power at the socket (plug another
appliance into the outlet to check).
The circuit breaker tripped or has blown a fuse.
The fridge temperature control is set too warm.
A general power outage has cut power to your home
(check the household lights).
The fridge turns on and off
frequently.
The room temperature is hotter than normal.
A large amount of food has been added to the fridge.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The fridge does not have the correct clearances.
There are vibrations. The fridge is not level.
The fridge seems to make
too much noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The fridge is not level.
The door will not close
properly.
The fridge is not level.
The door was reversed and is not properly installed.
The gasket is dirty or bent.
The shelves or balconies are out of position.
The fridge door will not
open.
If the door has just been opened, leave it for a few
minutes to allow the air pressure to equalise before
trying again.
If you experience a problem with your bar fridge, check in the following table for
solutions to help you solve the problem. If after these checks you still have a problem
with your bar fridge, contact our after sales support line for advice.