User manual
14
SD/MMC functions5.5
● Insert the device in the slot (23).
● Press the MD button (4) until SD/MMC appears on the display.
Playback will start automatically.
● Refer to the instructions under "USB functions" for explanation of the
functions available during playback.
● To remove the device, gently pull it out of the slot.
Advanced functions5.6
The following advanced functions are available: TA SEEK, PI SOUND,
RETUNE, MASK DPI, EON, BEEP, TA VOL, ADJ, AUDIO DSP.
● To enter and navigate through the menu:
Press and hold the SELECT button (13) for more than 2 seconds.•
To select the required function mode, press the SELECT button a •
number of times until this mode appears on the display.
To adjust/set the function, turn the VOLUME dial (13) until the setting is •
selected.
● To exit the menu at any time, press the DISP button (10), or wait for
approx. 8 seconds. After 8 seconds the unit automatically exits the menu.
TA SEEK
TA SEEK: when the currently tuned radio station does not receive any -
TP signal (for trafc announcement), or when the TP signal is too weak,
the unit automatically retunes to an alternative frequency with a
stronger TP signal.
TA ALARM: the unit does not automatically retune to an alternative frequency -
but gives a beep signal.
PI SOUND
SOUND: when 2 stations with a different program identication share the -
same frequency, the radio switches to the new channel for a few seconds
and then switches back again.
MUTE: the radio sound is muted. -