User Manual

284
Pad Parameter
In the Pad Parameter Q-Link Edit Mode, the Q-Link knobs control the same pad parameter for the each of the 16
pads in the current pad bank.
For example, if the Parameter is set to Level, the 16 Q-Link knobs will adjust the 16 independent Level settings for
each pad in the current pad bank. You could then set the Parameter to Pan and use the Q-Link knobs to adjust the
panning of all 16 pads.
Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameter you want to
control with the Q-Link knobs:
Mixer: general mixer parameters
Program: pad parameters (i.e., parameters used in Program Edit Mode)
Use the Parameter field to select the parameter you want to control with the Q-Link knobs.
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program:
Off
A
mp Env Hold Layer Sample Pan (1
–
4) LFO to Filte
r
V
elocity to Amp
Tuning
A
mp Env Sustain Layer Semi Tune (1
–
4) LFO to Amp
V
elocity to Pan
Filter Cutoff Filter Env Attack Layer Fine Tune (1
–
4) LFO to Pan Layer Direction (1
–
4)
Filter Resonance Filter Env Hold
V
elocity to Start LFO Wave Layer Offset (1
–
4)
Filter Env Amount Filter Env Decay
V
el to Filter Attack LFO Rate
A
mp Env Attack Filter Env Sustain
V
elocity to Env Amount LFO Sync
A
mp Env Decay Filter Env Release
V
elocity to Filte
r
V
elocity to Pitch
A
mp Env Release Layer Level (1–4) LFO to Pitch
V
el to Volume Attack
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.