User Manual

283
Pad Scene
In the Pad Scene Q-Link Edit Mode, the Q-Link knobs control your favorite 16 parameters for the currently selected
pad. You can select another pad simply by pressing it, allowing you to adjust the same 16 parameters for that new pad.
(These assignments are automatically saved with other user settings. Any project you load will use these assignments.)
To select a pad, press it.
Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameters you want
to control with the Q-Link knobs:
Mixer: general mixer parameters
Program: pad parameters (i.e., parameters used in Program Edit Mode)
Use the Parameter field to select the parameter you want to control with the Q-Link knobs.
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program:
Off
A
mp Env Hold Layer Sample Pan (1
–
4) LFO to Filte
r
V
elocity to Amp
Tuning
A
mp Env Sustain Layer Semi Tune (1
–
4) LFO to Amp
V
elocity to Pan
Filter Cutoff Filter Env Attack Layer Fine Tune (1
–
4) LFO to Pan Layer Direction (1
–
4)
Filter Resonance Filter Env Hold
V
elocity to Start LFO Wave Layer Offset (1
–
4)
Filter Env Amount Filter Env Decay
V
el to Filter Attack LFO Rate
A
mp Env Attack Filter Env Sustain
V
elocity to Env Amount LFO Sync
A
mp Env Decay Filter Env Release
V
elocity to Filte
r
V
elocity to Pitch
A
mp Env Release Layer Level (1–4) LFO to Pitch
V
el to Volume Attack
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.