Manual

105
Trim Mode
We recommend using Trim Mode to simply crop the end/ends from a sample.
To enter Trim Mode, tap the Trim/Chop button in
the lower-left corner so it says Trim.
Use the Start and End fields to set the position of
the start point and end point of the sample
(respectively). Alternatively, tap and drag the start (S)
or end (E) marker left or right, or use the first bank
Q-Link knobs to adjust the start point or the second
bank of Q-Link knobs to adjust the end point.
Trim Mode includes a loop function. When on, the
region of the sample between the loop point and
end point will repeat. This is useful when trying to
find an ideal spot to begin the sample. The loop
cannot be earlier than the start point.
To adjust the loop point, do any of the following:
• Use the Loop field.
• Tap and drag the start (S) marker (if Loop Lock is on) or the loop marker (if Loop Lock is off).
• Use the first bank of Q-Link knobs (if Loop Lock is on) or the third bank Q-Link knobs (if Loop Lock is off).
The top-most Q-Link knob provides coarse adjustment. The bottom-most Q-Link knob provides fine adjustment.
To turn Loop Lock on or off, tap the Loop Lock button. When on, the loop point is the same as the start point.
When off, the loop point is independent from the start point and indicated by a separate loop marker.
To turn the loop function on or off, tap the Loop button to cycle between the three modes:
Forward: When the loop reaches its end point, it will start playing again from the loop point.
Reverse: When the loop reaches its end point, it will play in reverse. When it reaches the loop point again, it will
return to the end point and continue playing in reverse.
Alternating: When the loop reaches its end point, it will play in reverse. When it reaches the loop point again, it will
start playing forward again from the loop point.
To switch between Forward and off, press and hold Shift, and then tap Loop at the bottom of the touchscreen.