User manual

Getting Started
Connecting
the Product
1. Connect the earphones to the earphone jack.
06
Connecting Earphones
1. Turn on the device and computer.
2. Press USB port slide, pull out USB port by sliding it to the direction
of arrow and connect the product with your computer. You will see
the screen where you can select connection mode.
- Power & Data: The connection between the product and the
computer is established and you can start transferring data.
- Power Only: The product is currently being charged.
Connecting to Your Computer
For successful computer/USB connection, disable all functions.
Check that the product is connected to a high-power USB 2.0 port. Connecting to a
keyboard or a USB hub without a power supply its own may result in malfunction.
File system does not support other than FAT32. Format this device into FAT32.
Verify that the product is connected to a high-power USB 2.0 port. Some low-power
USB ports built into certain peripheral devices, such as some types of keyboards
and USB hubs without internal power may not provide enough power to charge.
While the PC is switched to standby mode, the product may not be charged.
Turn the product off when charging. Leaving the device turned on during recharge
may prevent “Charge Complete” from being displayed.
The battery will be fully charged within about 2 hours 30 minutes. (Based on fully
discharged, power Off).
Charging times may vary if device is used during recharge.
Charge and store the product only at room temperature. Charging times may vary if
device is used during recharge.
The rechargeable battery is a consumable and the available usage time of charged
battery becomes shorter over time.