User manual

B20
42
Chapter5 Other Information
Using iriver plus 3
1. After connecting the product to the USB jack of your
PC using the USB cable, run iriver plus 3.
2. Select [Tools > Portable Device > Initialize Disk] and click
[Start] when the message to conrm initialization appears.
3. The initialization process is completed and the product is
disconnected from your PC.
Initializing Disk
1. After connecting the product to the USB jack of your
PC using the USB cable, run iriver plus 3.
The PC should be connected to internet.
2. Select [Tools > Portable Device > Firmware Upgrade] and
complete the upgrade process following the on-screen
instructions.
Upgrading Firmware
Note
You need to backup necessary les before initialization
as formatted les cannot be recovered.
Note
Do not disconnect the product from PC while downloading
rmware upgrade le. After the download is completed,
disconnect the cable to activate the rmware upgrade.
If the already installed rmware is the latest version, the
message to conrm latest version appears.
When connect the product to your PC, if there is latest
rmware, the instruction message appears automatically.