User manual

Using the Device 41
User Guide
Bluetooth Support Specifications
Profile: A2DP, aptX HD
Device performance may be affected during Hi-Fi playback.
(48 kHz or lower is recommended.)
Do not turn off the device while connected to Bluetooth.
Power cycle the Bluetooth device in case of malfunction.
Pairing methods may differ for each individual Bluetooth device.
Always refer to the respective instruction manual for details.
When connecting the device to a Bluetooth device, the distance
between the two must be within 20 cm.
Audio quality will degrade with longer distances and the pairing
may disconnect at a distance of 2 m (6.5 ft) or more. (Distances may
vary depending on device and environment.)
Crosstalk may be heard while using Bluetooth.
For multipoint devices, make the necessary connections prior to
use.
Car audio Bluetooth connections are not supported.
Malfunction, noise, and other undesirable effects may occur due to
the device's battery level and environmental factors:
If signal interference affects data transmission. (e.g. holding the
device while wearing a Bluetooth device, holding the device while
holding another electronic device, etc.)
If the device or Bluetooth headset's radio transmitters are touching
parts of the body.
If the transmission strength is affected by walls, corners,
partitions, etc.
If devices using the same frequencies cause interference. (e.g.
medical devices, microwave ovens, Wi-Fi, etc.)
Areas with an excessive amount of interference or weak signals.
(e.g. elevators, underground, etc.)
Removing a Bluetooth Device
1. Press [ ] to the right of the
paired device to be redirected
to the settings screen.
2. Select [unpair] to complete the
process.
40 Using the Device
User Guide
Using
Bluetooth
Connect a Bluetooth device to listen to music wirelessly.
Turning Bluetooth On/Off
A Bluetooth device must be paired
with the KANN prior to use. Refer
to the Bluetooth device's instruction
manual for details.
1. Select [ ] from the Notification
Bar, or select [On/Off] from [ -
Bluetooth].
Connecting a Bluetooth Device
1. Select the Bluetooth device from the list of available
devices.
Disconnecting a Bluetooth Device
1. Press the connected Bluetooth
device and confirm the message
prompt to disconnect the device.