Owner`s manual

AJP PR5 User’s manual – 3
rd
Edition – Rev 1 Page
29
Thoroughly wash the air-filter in special
cleaning fluid and allow it to dry well. Oil
the dry air filter with high-grade filter oil
and clean the air filter box.
For extra security, apply grease on the
back side of the filter, which mates with
air filter box.
Mount the filter together with the filter
bracket and fix them with the rubber
washer and the screw.
! WARNING !
Do not clean air-filter with fuel or
petroleum since these will damage
the foam.
Keep air filter clean and lubricated
(oil wet) to assure a more effective
protection to engine cylinder.
Never start your motorcycle without
air filter, otherwise dust or dirt may
penetrate in the engine and cause
damage or severe wear.
THROTTLE CABLE
Throttle grip and cable must be cleaned
and lubricated often, if motorcycle is
used or ride frequently off road (wet or
dusty areas), to keep a smooth
functioning.
Adjusting throttle cable
The throttle grip should always provide
for a backlash of 2-6mm, measured in
the adjusting screw outside the throttle
grip. Besides, with the engine running,
the idling speed must not change if you
turn the handlebar all the way to the left
or right.
To adjust throttle cable, draw back dust
protection, loosen the counter nut (1)
and turn the adjusting screw
accordingly (2). Tighten the counter nut
and check whether the throttle grip can
be actuated smoothly